Categories
mature quality singles hookup sites

Additionally, please make sure the settings in your sub aren’t interfering with appropriate measurement and bass administration:

Additionally, please make sure the settings in your sub aren’t interfering with appropriate measurement and bass administration:

Can it be that you’re playing content that is stereo “direct” mode? That turns down all electronic processing including bass administration and Audyssey. So that the great things about space modification are lost.

In establishing my subwoofer (Acoustech PL-200) and operating MultEQ XT, I experienced the polarity set to 0, when I had read in lot of places. The bass was underwhelming after running MultEQ XT. I was testing the subwoofer), do I need to re-run MultEQ XT if I change the polarity to 180 (which significantly changed the bass output when?

Likewise, I experienced ignored to alter the crossover in the subwoofer to “Out,” and alternatively left it on “In.” Should we run MultEQ XT once more after switching it?

Thanks for the assistance.

Hi George, there’s no necessity to rerun MultEQ after changing the subwoofer polarity. It shall don’t have any influence on the filters determined for the sub. But, if the crossover ended up being set to In once you went the measurements you might want to re-run just in case the filter had been interfering with the dimensions.

I am operating the Denon 1911 and like my bass. I’ve the known degree set beyond the 12 o’clock place, perhaps around 9 o’clock and my reading is really a -9.5. Is okay, or do i must turn it straight straight down and redo Audyssey.

You’re fine. This really is nevertheless within the range that the AVR can compensate. You simply want to turn straight down the sub degree (and run MultEQ again) in the event that reported level is –12 dB.